• 34
    of
    44

LOST WAX CAST BRASS KEY HOOK

£35.00 (inc VAT) £29.17 (exc VAT)
BUY

Tender’s key hook is cast in England from solid brass, using the lost wax method.

The key hook should be looped around a belt before the belt is fully threaded through jeans belt loops (the space inside is tight enough that it cannot come off the belt without taking the belt off again). Then, a keyring can be slipped over the up-pointing end of the S bend. Because the key hook is held flat against the belt, a keyring slips on or off the hook without too much pressure, but once it is hanging in the open section beneath the belt, it will not ride up and off of its own accord.

After testing out several dummy versions using coat hanger wire, Tender’s jeweller created the master pattern with hand tools. This was used to make a mould, into which wax is poured. The wax is packed in plaster, and molten brass is run in, melting away the wax and hardening inside the plaster. The plaster is then broken away and the exposed hook is filed and cleaned up.

The red version is stove enamelled red, by hand. Enamelling is a labour-intensive process which requires multiple layers of enamel to be built up onto the brass, with each layer being fired on a hot stove to create a smooth and hard surface. Enamel is quite a brittle material, so as the key hook is used, the enamel will start to chip away, revealing the brass underneath and giving it more character and personality.